调整使用 ZebraDesigner 软件时 ZPL 打印机的切割位置

文章编号:45125479

详细信息


 

Topic or Information

This solution is for the unusual occurrence where the ZebraDesigner driver for a ZPL printer is set to "Cut" and the actual cutting is not made at the correct location between labels

Applies To

ZebraDesigner Software being used with a printer using a cutter

详细信息

To adjust the cut position set the "Tear Off" adjustment parameter in the driver Properties.

  • Open the ZebraDesigner driver Properties and go to the "Advanced Setup" tab.
  • Check the "Tear off" Operation mode.
  • Change the value in the "Tear Off Adjustment" field to change the cut position.   A positive value will move it towards the unprinted label, a negative value will move it towards the just printed label.
  • Click "OK"
  • Check the "Cutter" Operation mode.
  • The "Tear Off Adjustment" will still be applied even though the entry position is grayed out on the display.

更多信息

Configuring Driver Settings  Read More>>

+ Product Codes

  • 105SLPlus 工商用打印机
  • 105SLPlus 工商用打印机
  • 110Xi4 工商用打印机
  • 140Xi4 工商用打印机
  • 170Xi4 工商用打印机
  • 220Xi4 工商用打印机
  • All Surface RFID 标签解决方案
  • G 系列 GX 桌面打印机
  • GX420Rx 桌面打印机
  • GX420d 桌面打印机
  • GX420t 桌面打印机
  • GX430d 桌面打印机
  • GX430t 桌面打印机
  • 工商用打印机
  • Xi 系列工商用打印机
  • ZD420-HC
  • ZD500 桌面打印机
  • ZD500 桌面打印机
  • ZD500R RFID 打印机
  • ZD500R RFID 打印机
  • ZM400
  • ZM600
  • ZT200 系列工商用打印机
  • ZT210 工商用打印机
  • ZT220 工商用打印机
  • ZT230 工商用打印机
  • ZT400 系列工商用打印机
  • ZT400 系列 RFID 打印机
  • ZT410 工商用打印机
  • ZT410 RFID 工商用打印机
  • ZT420 工商用打印机
  • ZT420 RFID 工商用打印机
  • ZebraDesigner
  • ZebraDesigner