Issue / Question
COUNTRY CODE NOT SELECTED error message is displayed
Applicable To
Link-OS Compatible Printers
Resolution / Answer
Setting the correct country code on the printer resolves the COUNTRY CODE NOT SELECTED error message is displayed issue.
This can be accomplished by sending the following SGD command to the printer by any available communications method, or by using the Zebra Setup Utilities and configuring the printer for your country as if it was a WLAN printer.
! U1 setvar "wlan.country_code" "my_country"
![]() |
IMPORTANT! The list of country codes is specific to each printer and depends on the printer model and its wireless radio configuration. The list is subject to change, addition, or deletion with any firmware update, at any time, without notice. |
To determine the country codes available on your printer, issue the ! U1 getvar "wlan" command to return all commands related to WLAN settings.
Locate the wlan.country.code command in the results and view the country codes available for your printer.
For example: The setvar sets the country code to Europe.
! U1 setvar "wlan.country_code" "europe"
Helpful Information: