RP4T Backward Prog Position Not Supported In Relative Mode

Article ID: 86254297

Issue / Question

RP4T Backward Prog Position Not Supported In Relative Mode

Applicable To

RP4T

Resolution / Answer

Relative program postions are specified in mm and represents the movement required to line up the RFID tag with the transponder, once the leading edge of the media is at the print line.


Firmware version SHCPT11z31 added support for Relative Program position.
All firmware versions after SHCPT11z31 will have the Relative Program position support.

However, only forward 'F' program positions are supported on the RP4T in Relative mode.

The program position can be set by entering a value into the 'p' parameter in the ^RS command

For more details on how to use the ^RS command to set a program position, please click this link. Read More>>

For help on solving VOIDS on the RP4T, we have an article that will help. Read More>>

+ Applicable Products

  • RP4T RFID Printers
  • RP4T RFID Printers