Adjusting the EC, X and Y offsets on ZXP Series 1 and ZXP Series 3

Article ID: 52073990




Procedure on how to change the X and Y offsets and modify the End of Card (EC) setting

Applies To

Zebra ZXP Series 1 and ZXP Series 3 Card Printers


The X and Y offsets are used to center the image on the card or to align the image with an edge. The EC setting is used to move the edge of the image away from or closer to the trailing edge of the card.  This can help with image alignment and ribbon breaking issues.


See the following link for detailed instructions for making these adjustments.  Read More>>