Eliminating the white gap along the edges of the card on ZXP Series 9 Card Printers

Article ID: 18480887

Details

Topic or Information

On occasion you may see a small white line or gap between where your printed image ends and the actual end of the card is located.  The following information can help to correct this.

Applies To

ZXP Series 9 Card Printers

Details

To print an image edge to edge on the card, ensure the image is sized to fully cover the card, 1024 by 648 pixels. 

Open the ZXP Toolbox and select “Printer Configurations”

User-added image

 

Film print X offset (dots):  Film print Y offset (dots): 
This is the number of dots (300 dpi / ~3 mils/dot.) to shift the image to align it on the media. Increasing these values move the image right while decreasing them moves the image left. This parameter can be used to center the image on the card, or to align it with an edge. The adjustment range is: Minimum -50, Maximum 50. This is the number of mils to shift the image to align it on the media. Increasing these values moves the image up while decreasing them moves the image down. This parameter can be used to center the image on the card, or to align it with an edge. The adjustment range is: Minimum -100, Maximum 100.

 

Source

Victor A