Issue / Question
How to configure DataWedge for DS3578 Bluetooth scanner connected to WT41N0 CE7.0
Applicable To
WT41N0
DS3578 Bluetooth scanner
Resolution / Answer
Note:
This article assumes the DS3578 in SPP mode is paired and connected to WT41N0
- Go to Start> Settings> Control Panel and launch DataWedge
- Select Advanced Configuration
- Select Profiles> Profile0> Input> Serial> COM5 BT Serial
- Tap Enabled to enable COM5 BT Serial (this will put a check make just before the #1)
- Tap Back 3x
- Select Routes> Route0> Input> Pluginin scanner>
- Tap Serial to enable. (this will put a check make just before the #2)
- Tap Back until you are back Advanced page
- Tap Exit to exit Advanced Configuration
- Tap Running to start DataWedge
- Make sure the Status = Ready (green check mark)
At this point, for testing purposes, you can now scan into MS Wordpad.