Issue / Question
How to pair and connect a DS3678 Bluetooth scanner to MC92N0 Windows CE7.0 mobile computer?
Applicable To
MC92N0 CE7.0
DS3678 Bluetooth scanner
Resolution / Answer
A. DS3678 setup
- Scan the barcode 'Set Factory Defaults' on page 131 of the DS36X8 Product Reference Guide. Download>>
- Scan the barcode 'SSI Bluetooth Classic (Non-Discoverable) on page 81. Default is Cradle Host.
B. MC92N0 setup
- Start > Programs > BTScannerCtlPanel > Enable check box.
- Select target COM port. Example COM9.
- Then choose “Save and Exit”
- Start > Programs > BTUI > Pairing Barcode (scan this barcode with the DS3678)
- Tap back arrow to close pairing barcode
- Tap 'X' to close BTUI (BT Information)
C. DataWedge Configuration
- Launch Datawedge on the MC92N0
- On Datawedge main menu, click “Running” twice. Choose “Basic Config” afterwards
- Choose Option 1 – Scanner Input
- Choose “Bluetooth SSI Scanner Driver” (option 2)
- Choose “Enabled” therefore putting a check mark next to it, then click “Home” on top right
- Exit (option 0), then OK to acknowledge
- Tap on Running to toggle to Yes
- At this point, DataWedge will show a status of Ready
- Tap OK to close DataWedge
* At this point, the DS3678 is now connected and paired. You can test using DataWedge Demo