Issue / Question
How to enable support for Preboot Execution Environment (PXE) - network boot?
Applicable To
ET51 Windows 10
ET56 Windows 10
Resolution / Answer
1. Connect to Charge and Communication Dock (P/N CRD-ET5X-1SCOM1)
2. Attach USB keyboard and Ethernet cable
3. Boot to BIOS menu (shutdown, power on, when Zebra logo is seen, press ESC button from keyboard)
4. Select 'Setup Utility'
5. Select Boot
6. Select 'Network Stack' - Select Enabled
7. Select 'PXE Boot capability' - Select 'UEFI: IPv4' or 'UEFI:IPv6' or 'UEFI:IPv4/IPv6'
8. Select F10 to 'Save and Exit'
9. Tap Yes to 'Exit Saving Changes' prompt
The device will reboot
10. When Zebra logo is seen, press ESC button from keyboard
11. Select 'Administer Secure Boot'
12. Select 'Enforce Secure Boot' - Select Disabled
13. Select F10 to 'Save and Exit'
14. Tap Yes to 'Exit Saving Changes' prompt
The device will reboot
15. When Zebra logo is seen, press ESC button from keyboard
16. Select 'Boot Manager'
17. The 'EFI Network 0' for IPv4 or IPv6 option should be visible in Boot Manager
18. Select this to start PXE network boot