Enable Continuous Scan in Android Datawedge

Article ID: 30187654

Issue / Question

How to configure Android Datawedge to perform continuous scanning?

Applicable To

Android 5.0, Android 6.0, Android 7.0

Resolution / Answer

Configuration steps

  1. Open the Datawedge setting.
  2. Select the Profile.
  3. Look for Reader params under Barcode input section.
  4. Change Aim Type as "Continuous Read" and Beam Timer as 0.


Extra Note

On above configuration, scanner beam will continuous to light up if using soft trigger. In hard trigger mode, scanner beam will continuous to light up only if trigger button is hold on.

+ Applicable Products

  • TC20
  • TC51
  • TC56
  • TC70x
  • TC75x
  • TC8000