Install, Setup and Configure RFID Input Plugin for DataWedge for Windows Mobile Devices

Article ID: 03322057

Issue / Question

How to install and configure RFID Input Plugin for DataWedge for Windows Mobile devices to read RFID Tags and transfer Tag data to a foreground application?

Applicable To

MC3190-Z, MC9090-Z and MC9190-Z

Resolution / Answer

Overview

This RFID Input Plug-in is a Zebra input plug-in for use with Zebra DataWedge. DataWedge RFID Input Plug-in provides way to read RFID Tags by Zebra RFID handheld devices and transfer Tag data to a foreground application through output plug-in. DataWedge RFID Input Plug-in uses RFID3 APIs to communicate with RFID radio.

1. Download and install RFIDInputPlugin.msi on a PC.
2. Install RFID Input Plug-in for DataWedge unto supported mobile computer like the MC9190-Z. Read More>>




3. Restart DataWedge (Stop/ Start DataWedge)
4. Configure DataWedge

Advanced Configuration> Profiles> Profile0> Input> RFID> Mobile RFID> Enabled (make sure there is a check mark next to this)
Advanced Configuration> Profiles> Profile0> Routes> Route0> Input> Plugin> RFID (make sure there is a check mark next to this)

5. Save then exit DataWedge

At this point, when you hold the scan trigger, the device should read supported Tags that are within read range. These Tags will be read as keyboard input.


 

+ Applicable Products

  • MC3190-Z RFID Reader
  • MC9090-Z RFID Reader
  • MC9190-Z RFID Reader