Setting a timeout interval when scanning same and different barcodes

Article ID: 63267002

Issue / Question

How can I control the time the scanner waits before decoding a different or same barcode type?

Applicable To

LS2208, DS81x8, DS22x8, 3600, DS4608, DS4308, LI4278 , DS9908

Resolution / Answer

To select the timeout between decodes for the same symbol, scan the following bar code, and then scan two bar codes from the below Numeric Bar Codes that correspond to the desired interval, in 0.1 second increments.



To select the timeout between decodes for a different  symbol, scan the following bar code, and then scan two bar codes from the below Numeric Bar Codes that correspond to the desired interval, in 0.1 second increments




Numeric barcodes 0-9

                                                 



                                                             



                                                                




                                                           




                                                                     

 

+ Applicable Products

  • DS2208-HC
  • DS2208-SR
  • DS2278-HC
  • DS2278-SR
  • DS4608-DL
  • DS4608-DPE
  • DS4608-HC
  • DS4608-HD
  • DS4608-SR
  • DS4608-XD
  • DS8108-HC
  • DS8108-SR
  • DS8178-HC
  • DS8178-SR
  • DS9908-HD
  • DS9908-SR
  • DS9908R-HD
  • DS9908R-SR
  • LI3608-ER
  • LI3608-SR
  • LI3678-ER
  • LI3678-SR
  • LI4278
  • Symbol DS4308
  • Symbol DS4308-HC
  • Symbol LS2208 General Purpose Bar Code Scanner