How Do I Set TKIP on an AP4131 Using the GUI Interface?

Article ID: 90950916

Question

How Do I Set TKIP on an AP4131 Using the GUI Interface?

Answer

To enable TKIP on a Symbol AP-4131 using the browser interface, follow these steps:
 
  1. Connect to the AP via HTML interface.
  2. Click the Network link and configure ESSID & Country code (as well the other settings if they have not been set).
  3. Click Save Settings.
  4. Click the Security link and then select Modify Authentication and Encryption Setup.
  5. Click the radio button to enable Pre Shared Key and TKIP.
  6. Click Save Settings.
  7. Click Modify for TKIP Encryption Setup.
  8. Enter the TKIPPassPhrase and Press ENTER. It is important to press ENTER at this step! This will generate the actual Key.
  9. Click Save Settings then click Authentication and Encryption Setup.
  10. Click Save Settings again and then click Security Home Page.
  11. Click Save Settings then click the Special Functions link and reset the AP.