Peel Mode Operation Xi Series and 105SL

Article ID: 57774217



Topic or Information

 Peel related discussion

    Configuring a printer for peel mode

    Loading the media for peel operation

    Peel issues


Applies To

Xi Series Printers, Pax 4, and 105 Series Printers


Peel Mode operation procedure - Check the following solutions

    If the labels are not stopping make sure the printer PRINT MODE is set for PEEL. Labels may not stop at peel position if PRINT MODE is set otherwise.

    You can adjust the resting position of the label with the TEAR-OFF position setting from the LCD Display. Before adjusting the resting position assure the printer is properly calibrated so that each label is stopping as the same position. Small adjustments can then be made with the TEAR-OFF setting.

    If the labels are not peeling and you have verified they are loaded correctly check with your label provider. The labels should separate from the liner when bent sharply over the peel bar and if this is not occurring or is unreliable your label supplier should be consulted.


Peel Mode procedure information details Read More>>


+ Product Codes

  • 105SLPlus Industrial Printers
  • 105SLPlus Industrial Printers
  • 110Xi4 Industrial Printer
  • 140Xi4 Industrial Printer
  • 170Xi4 Industrial Printer
  • 220Xi4 Industrial Printer
  • R110Xi4 RFID Printer
  • Xi Series Industrial Printers