Question
Removing ISO Data ID’s From the a Bar Code when using Wavelink Emulation Software
Article ID: 88408279
How to remove ISO Data ID’sFrom the Beginning of a Bar Code Using Wavelink Emulation Software?
Answer
These data ID’s cannot be modified. The list is pre-programmed and cannot be added to.
The following ISO data ID’s can be removed from the beginning of bar codes:
To remove the ISO ID from the barcode
The following ISO data ID’s can be removed from the beginning of bar codes:
- 1T
- P
- 1P
- 1L
- Q
- 1S
- 1Z
To remove the ISO ID from the barcode
- Change the Emulation parameter REMOVE ISO IDS to YES
- Save change and sent the Config Only to the unit
