Setting the ZT200 Series printer parallel port mode using the Set Command

Article ID: 57716238

Details


 

Topic or Information

ZT200 Printer Parallel Port Setup and Configuration for Unidirectional and Bi-Directional

Applies To

ZT200 Series Printers

Details

The parallel port on the ZT Series printer can be configured to support unidirectional “compatibility model” or bidirectional “nibble mode”. By default it is set to bidirectional. The printer will negotiate with any parallel port connection or print server to determine which communication methods can be supported.   The following Set Command is supported in the ZT Series (V72) and is documented in the current ZPL manual. Use this command to configure the parallel port if manual changes to this mode are needed to support your interfacing device.

User-added image