Xi4 Series -- Setting The IP Address Using Front Panel LCD Display

Article ID: 60937273

Issue / Question

How to use the front panel to set or change TCP/IP settings. IP, Subnet, & Default Gateway addresses.

Applicable To

- ZebraNet Print Server II and ZebraNet Print Server 10/100 (internal or external)

- ZebraNet Wireless and Wireless Plus Print Servers  

- 110Xi4, 140Xi4, 170Xi4, 220Xi4, R110Xi4 Printers

Resolution / Answer

For Xi4 Series:


Note:  The IP address that you change from the LCD menu of the printer is that from the "Active Printserver" Read More>>
To determine the current "Active Printserver" Read More>>


Press Setup/Exit
Press the left Previous< button until you see IP Protocol - then press the Plus or Minus button to change the setting.  
You will be prompted for a password.  The default password is 1234.  The top Plus button increments the number.  The Bottom Minus button moves the cursor to the right.  Once the password is entered on the display, press the Next/Save button.  
Now press Plus or Minus button again to set the IP Protocol you want to use.  The IP Protocol must be set to Permanent in order to manually change the TCP/IP settings. 
Then press the right Next/Save > button until you see the TCP/IP setting you wish to change.  IP address, Subnet Mask or Default Gateway.  Now you can use the upper + or lower -  buttons to change the IP setting selected, without having to re-enter the password..  
To save the changes, press Setup/Exit then Next/Save, printer should display Saving Changes Permanent.

Additional information:
Xi4 User guide Download>>
ZebraNet 10/100 Internal Printserver User Guide Download>>

+ Product Codes

  • 110Xi4 Industrial Printer
  • 140Xi4 Industrial Printer
  • 170Xi4 Industrial Printer
  • 220Xi4 Industrial Printer
  • Xi Series Industrial Printers
  • ZebraNet 10 100 Print Server
  • ZebraNet PrintServer II
  • ZebraNet Wireless Plus Print Server
  • ZebraNet Wireless Print Server