ZPL ~JD Hex or ASCII Dump Command Details

Article ID: 91262416

Details


 

Topic or Information

A user might need to use a ZPL command to put the printer into Hex Dump mode.
I don't have a display. How do I enable hex dump mode?

Applies To

Zebra Printers that support ZPL

Excludes: 2824 Series, 2844 Series, S4M (E53 Firmware Version), 888 DD/TT Series, MZ Series, ZQ110, EM220, EM220II

Details

The ZPL command "~JD" will cause the printer to print the received data sent via the port it was received.

Note: If using the command over a Network you must send the expected data from the same connection. You cannot enable the hex dump and then send data from a different port or connection.

See the ~JD command for details Read More>>

 

To turn off your Hex Dump use ~JE Read More>> 

 

Source

ZPL Manual