ZT2x0, ZT4x0, and ZD500/R Front Panel Button Commands

Article ID: 44121093



Topic or Information

You can utilize the front panel buttons to trigger certain actions to be performed by the printer or reports to be printed by the printer

Applies To

Link-OS ZT200 Series, ZT400 Series, and ZD500 Series Printers


Procedures that can be run during power-up (hold buttons in while unit is off, turn unit on with buttons held in and continue holding buttons for 5-10 seconds):

Network/Settings Configuration Label:

Pause Test (Printhead Test):

Feed Test (Speed/Darkness Test):

Restore Printer Defaults:
Pause + Feed

Restore Network Defaults:
Pause + Cancel

Sensor Profile:
Feed + Cancel

Procedures that can be run when unit is already powered on (hold for 2 seconds) :

Network/Settings Configuration Label:
Feed + Cancel

Media/Ribbon Calibration:
Pause + Cancel

Communication Diagnostic Mode:
Pause + Feed

+ Product Codes

  • All Surface RFID Label Solution
  • ZD410 Series
  • ZD410D
  • ZD420 Series
  • ZD420-HC
  • ZD420C
  • ZD500 Desktop Printer
  • ZD500 Desktop Printer
  • ZD500R RFID Printers
  • ZD500R RFID Printers
  • ZT200 Series Industrial Printers
  • ZT210 Industrial Printer
  • ZT220 Industrial Printer
  • ZT230 Industrial Printer
  • ZT400 Series Industrial Printers
  • ZT400 Series RFID Printers
  • ZT410 Industrial Printer
  • ZT410 RFID Industrial Printer
  • ZT420 Industrial Printer
  • ZT420 RFID Industrial Printer