ZE500 “Error on Pause” Command

Article ID: 79619505

Issue / Question

Is there a ZPL or SGD command to enable/disable 'Error On Pause' for the ZE500?

Applicable To

ZE500

Resolution / Answer

There is no ZPL or SGD command to enable or disable 'Error On Pause' on the ZE500.


There are 2 ways to enable or disable 'Error On Pause' on the ZE500:
1. Set it through WebView by entering the IP Address of the printer into the address bar of a web browser bringing you to the printer's homepage.
Then click on 'View and Modify Printer Settings', enter password, click on Advanced setup, and scroll down until you see “Error on Pause” setting, set to “enabled” or “disabled”. 
2. Set it through the front panel: Scroll until you see “Error on Pause” setting. 

+ Applicable Products

  • ZE500 Print Engines