Adjusting the End of Card Using the +EC Command in a Zebra Card Printer
Article ID: 65012570
Description This solution is useful for:
Applies To All Performance and Value Class card printers Details The end of card "EC" parameter defines the point where printing stops on the card. If printing occurs past the end of the card the ribbon can be unintentionally cut by the printhead. Note: Procedure for making these changes is labeled for a ZXP Series 3. However, the commands and location of these settings are similar, if not the same, as the Performance and Value Class printers. Helpful Information To access the EPCL Programming Manual Read more>> |

+ Product Codes
- P100i
- P110i
- P120i
- P330i Card Printer
- Value Class Card Printer
- ZXP Series 1 Standard Card Printers
- ZXP Series 1 Standard Card Printers
- ZXP Series 3 Card Printers
- ZXP Series 3 Professional Card Printers
- ZXP Series 3 with Security Enclosures
- ZXP Series 3C Card Printers (China Only)