Adjusting the Loop length on a KR403

Article ID: 88635904

Details


 

Topic or Information

Adjusting the loop length on Zebra KR403 Printer

Applies To

Zebra KR403 Kiosk Printer

Details

The following command adjusts the loop length on the KR403:

! U1 setvar "media.present.loop_length"  "value"

Values:

0 = paper is fed straight through the presenter .

3 - 1023 = loop length in mm.

Default:

50 = gives a loop of approximately 50mm.

example:

! U1 setvar "media.present.loop_length" "0"

This will turn off the loop option on the KR403.

The following command determines the maxium allow length for the loop.

! U1 setvar "media.present.loop_length_max" "value"

Values:

0 = paper is fed straight through the presenter.

3 - 1023 loop length in mm.

Default:

600 = gives a loop of approximately 50mm.

example:

! U1 setvar "media.present.loop_length_max" "600"