Issue / Question
- Decoding sound is too low
- How to adjust the Beep volume to the highest(3)?
Applicable To
DataWedge 3.x
Resolution / Answer
Start > DataWedge > Basic configuration > Scanner input > Block Buster Imager (for example) > More > Feedback > Good decode > Beeper > Enabled > Volume > enter 3 > Save > Back > Home > Exit > OK
**Make sure the WaveFile option is disabled
Start > DataWedge > Basic configuration > Scanner input > Block Buster Imager (for example) > More > Feedback > Good decode > WaveFile > Uncheck Enabled