Importing Datawedge Settings Using Stage Now

Article ID: 99448702

Issue / Question

How to Import Datawedge Settings Using Stage Now

Applicable To

Android OS

Resolution / Answer

Open Datawedge and configure it as needed, once you will be done with the configuration export the settings following the steps below:

Open Stage now on your PC, and click create a new profile

Next you will prompt to select the MX version you have on the terminal. (Settings>about device>SW components>Mx>MXMF version)

Select Expert mode and click create. You will be asked to give a name to the profile.
After this you will see the list of manager settings  available, for this case we will add  FileMangr by clicking on the "+" sing,

Click on add to set the target patch and the location of the file. Your PC will act as a server, therefore your PC and devices must be on the same network.
Target patch will be:  /enterprise/device/settings/datawedge/autoimport/datawedge.db

Click continue and complete profile. In the next window mark the Stage now client depending on your scan engine 1D or 2D.  Make sure the your PC in on the same network as the terminal, you can check the IP in the upper right corner. By clicking on Test a barcode will be generated, this baroce must be scanned from the terminal while having open stage now client.


+ Applicable Products

  • DataWedge
  • MC3300
  • MC3300R Series
  • TC20
  • TC51
  • TC55 Touch Computer
  • TC56
  • TC70
  • TC70x
  • TC75
  • TC75x
  • TC8000
  • WT6000 Wearable Terminal