How to Enable the Aiming Dot on the Long-Range MC90xx–GJ?

Article ID: 20789093

Question

How to Enable the Aiming Dot on the Long-Range MC90xx–GJ?

Answer

The aiming dot will not appear when the trigger is pressed.  Instead only the flat scan line will emit from the scanner.

Change the Aim Mode to “Dot” and the Aim Duration to Timed Release or Timed Hold.
  • Timed Hold – When the trigger is pressed, the dot will emit for a specified amount of time which can be set from the Aim Duration field, located between Aim Type and Aim Mode.  After this time, the laser will change to a line for scanning the bar code.
  • Timed Release – The dot will emit when the trigger is pressed, until it is released.  At that point it will turn into a line for scanning the bar code.