How to Set Up Avalanche Enabler to Auto-Launch when a Cold Boot is Performed?

Article ID: 12174865

Question

How to configure the Wavelink Avalanche Enabler to Auto-Launch after a Cold Boot?

Facts

Avalanche Enabler is not configured to Auto-Launch.

Answer

Avalanche Enabler will not start when a Cold Boot is performed.
  1. Start Avalanche Enabler on PC.
  2. Select Enabler Settings.
  3. Select the Startup/Shutdown tab.
  4. Select “Monitor and Launch update utility” under the “At System Startup” heading.
  5. Select OK.
  6. Make sure you have an active ActiveSync connection to the PPC or CE.NET device.
  7. Select the Config Only icon.  This will transfer the updated configuration to the device.
  8. Cold Boot device.