Modifying the Tear off position CPCL
Article ID: 58865030
Description Using CPCL you can change the tear off position of your label if you require it to feed past the tear bar Applies To All CPCL enabled Zebra Mobile Printers Excludes: ZQ110, EM220, EM220IIRequirements Communication with printer and the ability to send files/commands to the printer. Read More>> Overview The media tear off position can be modified using the PRESENT-AT command. The PRESENT-AT command can be sent inside of a label format or can be used with a UTILITIES command. Procedure Command Syntax: command length delay command: PRESENT-AT length: The length in dots that the media will advance after printing and to be retracted before printing the next label delay: The time interval in 1/8 of a second that the printer will delay after printing before advancing the media (Example: A value of 4 would be equal to 1/2 second (4/8)) Example: ! 0 200 200 203 1 ! UTLITIES One can also include a PRESENT-AT command inside of a file that is executed on bootup such as the autoexec.bat, config.sys or run.bat files. Example: ! DF RUN.BAT Helpful Information USB Communication Information Read More>> CPCL Programming Guide Read More>> |

+ Product Codes
- EZ320 Mobile Printers
- P4T Mobile Printers
- P4T Mobile Printers
- QL Series Mobile Printers
- QL320 Mobile Printer
- QL420 Mobile Printer
- QLn Series Healthcare Mobile Printers
- QLn Series Mobile Printers
- QLn220 Healthcare
- QLn220 Mobile Printer
- QLn320 Healthcare
- QLn320 Mobile Printer
- QLn420 Mobile Printer
- RW 220 Mobile Printer
- RW 420 Mobile Printer
- RW 420 Print Station
- RW Series Mobile Printers
- ZQ500 Series Mobile Printers
- ZQ510 Mobile Printer
- ZQ520 Mobile Printer
- ZR300 Series Mobile Printers
- ZR338 Mobile Printers
- ZR600 Series Healthcare Mobile Printers
- ZR600 Series Mobile Printers
- iMZ Series Mobile Printers
- iMZ220 Mobile Printer
- iMZ320 Mobile Printer