RFID COUNTRY CODE NOT SELECTED Error Message Is Displayed

Article ID: 12043583

Details


 

Topic or Information

“RFID COUNTRY CODE NOT SELECTED” error message 

Applies To

ZD500R

Details

When a ZD500R is taken new out of the box for the first time and powered on, it is normal for it to display the “RFID COUNTRY CODE NOT SELECTED” error message as shown below:-

 User-added image

To set this please refer to the "rfid.country_code" command in the RFID Programming Guide 3 for the ZD500R printer. Read More>>

The RFID Programming Guide is also within the following link.  Read More>> 

**Important WARNING - Please note that this is a one-time setting and it cannot be changed once set  **

  • For example, if the printer is being used in Europe, send the below command string:-

! U1 setvar "rfid.country_code" "europe"

  • For example, if the printer is being used in USA or Canada, send the below command string:-

! U1 setvar "rfid.country_code" "usa/canada"

  • Other Available Values:
    not selected, no region code, usa/canada, argentina, bolivia, brazil, chile, colombia, costa rica, dominican republic, el salvador, ecuador, guatemala, honduras, mexico, nicaragua, peru, puerto rico, uruguay, venezuela, europe (all EU member states and EFTA), albania, bosnia, croatia, georgia, russia, turkey, ukraine, australia/nz, bangladesh, hong kong, india, indonesia, japan, malaysia, pakistan, china, philippines, singapore, korea, taiwan, thailand, vietnam, israel, saudi arabia, south africa, uae
  • You can then send the following command string to make sure the correct setting has been saved:-

! U1 getvar "rfid.country_code"