Chat with us
Loader
Establishing connection, please wait while we connect you.

Workabout Pro 4 Operating System BSP 2.0 - Hotfix CFE 2.5 Release Notes

Introduction

The Workabout Pro 4 is a modular, industrial hand held computer. Microsoft Windows CE Professional 6 is one of the two OS options for this device.

Description

 The following issues have been resolved in this hotfix CFE OS:

SPR NO

Synopsis

26861

Improve DataWedge behavior when switching to and from SCS mode

27248

Improve low battery handling

27450

Improve logging into TLS 1.0 and SSL 3.0 enabled sites

27156

Allow scanning into TekTerm barcode fields in SCS mode 

 

Contents

P728XC60CPMI020500.img

P728XC60CTMI020500.img

P728XC60EFMI020500.img

P728XC60JPMI020500.img

P728XC60KOMI020500.img 

Device Compatibility

This software release has been approved for the following Zebra devices.  

Device

Operating System

BSP Version

Workabout Pro 4 (7528)

Windows CE 6.0 Professional

v2.5.43052

 

Installation Requirements

  • WAP Pro 4 (7528) with CE 6.0 Profissional device.

  • If previously installed, uninstall '7528 Release 2.3 OS Patch v1.1'.

  • MicroSD card 2GB or greater formatted as FAT32.

  • OR USB Memory stick and WAP 4 docking cradle

Installation Instructions

To update the operating system software of the WAP 4, follow the procedure below: 

  1. If previously installed, uninstall '7528 Release 2.3 OS Patch v1.1' (Instructions below).

  2. The firmware can be upgraded using a USB Memory Stick or using a microSD Card.

  3. The firmware file must be renamed 7528os.img

  4. Copy the file containing the firmware upgrade to the root directory of the USB memory stick or Micro SD card.

  5. Install the USB memory stick into the docking cradle or install the Micro SD card into the WAP 4 in the Micro SD slot in the battery compartment.

  6. Press and hold down the [Blue FN] key, the [SCAN] key and the [Power] key, simultaneously for a minimum of six seconds.

  7. When the update is complete, the device reboots to the main operating system.

  8. Remove the MicroSD card from the device to prevent the device from performing the upgrade process again on the next cold boot, and then disconnect external power. The device is now ready to be used.

To uninstall 7528 Release 2.3 OS Patch v1.1, follow the procedure below:

    1. Delete contents of \Application\tiinit folder.

    2. Clean start device or update operating system software.

 

Release Date

October 6, 2015