How Do I Create a User ID and Password Bar Code to Log into an AS/400?

Article ID: 44017799

Question

How Do I Create a User ID and Password Bar Code to Log into an AS/400?

Answer

Using a barcode generating utility, you can make barcodes that will represent the user name and password that Wavelink Emulation Software uses to log into an AS/400
  •     Make sure Full ASCII is Enabled in the WaveLink Emulation Software (Emulation Parameters)
  •     Make sure that the barcode generating utility is setup to create Code 39 Full ASCII barcodes.
  •     In the barcode generating utility, key in the User Name and put a TAB at the end.  The TAB is HEX value 09.   Print out the barcode.
  •     In the barcode generating utility, key in the Password and put an LF (line feed) at the end.  The LF is HEX value 0A.  Print out the barcode.